The chassis design of new energy vehicles should take into account three aspects

First of all,Chassis designIn the process, both the framework and its subsystems need to remain unchanged. Secondly,Automobile chassis subsystemAppropriate improvements should be made based on the original framework. Of course, the reducer interface of the new power system should also be changed. On the basis of the part design, it should also be usedCAEThe analysis method is applied to the suspension system to reduce noise. Thirdly, the layout of the rear cabin of the vehicle body will change with the new design scheme adopted by the subsystem. After a series of detailed calculations, the safety factor of the suspension system was ensured. Otherwise, the subsystem should be reset. At this point, the task of the suspension system should be adjusted, and the distribution of the front axle load and rear axle load of the new energy vehicle should be analyzed. It is found that the parameters of the suspension system should be redesigned. Determine the four-wheel alignment parameters of the suspension and use themAdamsConfirm the analysis, but it is best to ensure that the original design plan is combined with the actual situation, effectively saving the development cycle and reducing the development cost.